Related Forum Threads
- Custom Critter Carriers,Coops,Tractors,Hutches;etc Last post on 2/23/13 at 7:34pm in Where am I? Where are you!
Resin Chicken Coop
Edited on 5/14/13
- The Little Red BarnEdited on 4/29/13
- ChooksChick's Hints for HenthusiastsEdited on 3/30/13
- Covered Wagon and Chik'n Hut Mobile Chicken Coops
- topicSmall Coops
Alphabetical Article List
Thechickenproject's Chicken Coop
Welcome to our Coop Page!
While on a trip to Virginia, we stopped at a local Tractor Supply and a swap meet for chickens and ducks was going on. Our nine year old daughter put on the sad eyes and begged for a pet chicken. Not knowing anything about the care, we originally told her no, only to change our minds when we returned to New Jersey.
We agreed to allow her three chickens and no roosters. They couldn't annoy the neighbors, no smell, and the coop had to be pleasing to look at. If these criteria were not met, the chickens would have to go.
That said, we shopped the local chain hardware store in their scrap lumber department for as much material as we could get. Fifty cents a four foot board is a lot cheaper than buying conventional sized lumber. Two by fours and trim were ripped down from 2x10's with a table saw. The roofing was donated from a friend. The most expensive material was the hardware cloth to secure the run and coop.
As for plans, I should have bought them. The coop was designed using different aspects of other coops in this forum. (Thanks to all of you that submitted plans.) Basically, we wanted the coop to have a run underneath, be tall enough to work under and have a walk in people door to the run.
We started off strong. I picked an area behind the fence that I could clear. Moved the fence and started building on a nearby fire pit deck.
That’s when I noticed that a four foot wide frame would not fit into a three foot wide opening. While trying to lift the frame over the fence, I also found out that you can not use 16 gauge finish nails for framing. When everything had fallen apart, it was back to the drawing board. I decided to use regular nails and a hammer on the next design.
Another good idea is to build it in place. Something this big is not designed to be moved.
Next idea was to anchor it down with 4x4 corners, buy 2x4x8’s for the sides to add stability. The coop will sit 4 feet high with the run underneath and extend four feet further. We also decided to extend the roof the full length of the run to help with sun and shade.
The walls are built from ripped 2x3’s with exterior shed siding I found in the scrap bin at the store. I planned an opening for the nest boxes, clean out, large screen doors and a 4” x 36” window.
Next was the roof, shingles and trim. The tar paper was bought while the shingles came from a buddy who just finished repairs on his house. The OSB for the roof again came from the scrap bin.
At this point, things went pretty quick. The painting, hinges and handles were completed.
My wife wanted shutters put on the inside window. I used plexi-glass to make the shutters and a removable screen of hardware cloth. The sliding cleanout door has a lock on the back and I made a removable plexi-glass window for the small window on the side.
I had a problem with the height of the coop and the length of the ladder. The original plan was a pop door in the floor. The height of the coop would require the ladder to extend all the way to the people door, thus taking up too much run space. The entrance hole in the coop was also too large.
I modified plans for the nest box off the Purina Mills site. Using the full width of the coop, I built two nest boxes and used the rest of the space for the pop door. This adds 14 inches to the back of the coop and creates an overhang to shelter the ladder from the weather. With a landing half way up, I can turn the ladder and keep the birds sheltered while entering and exiting the coop. Hinges and a pulley system were added to secure the second half of the ladder to the floor of the coop.
Once completed, mulch was added to the run and surrounding area. Hardware cloth was added above the people door. We still have to finish the sod and sprinklers on the outside of the run. Solar lighting has been added to the top of the fence line and lights the area up at night. I also plan a motion security light to deter predators.
We brought the birds home on July 19th. We planned on three but came home with five. Two EE’s, one Polish, one Frizzle and one cuckoo maren. All are seven weeks old except for the Frizzle which is three months.
Since they have been home, I’ve needed to make some modifications. The ladder is at a 40 degree angle and needed more slats added to the ramp. The original spacing of 5 inches was too far.
I didn’t realize chickens were afraid of the dark so I have to shine a light in the coop in the evenings to get them to go in. I plan on an interior light on a sensor for dusk.
The roost board was too high for young chicks. I have added two more boards at lower steps to act as a ladder to reach the upper roost.
Things I like about the coop:
- The height allows for me to walk in and clean. I have easy access to the birds.
- The cost was lower due to recycled lumber.
- Easy access to the coop for cleaning and maintenance.
- Completely wrapped in hardware cloth to keep out predators.
Things I would do differently:
- Buy an actual plan. I spent too much time correcting mistakes.
- Wire the coop for electric before the birds occupy it.
- Never plan on “only three chickens”.
I’ve only had chickens for four days at this point. I hope to add more posts and information as time goes by. The birds already put themselves to bed and are adapting well to their new surroundings. They are still having issues with leaving the coop in the mornings. I think they are hesitant about using the hole in the floor.
UPDATE: We are into week five of owning chickens.
- I'm glad I went with the mulch for the run. I changed the mulch after three weeks. It was looking thin and dirty. Since I get it free from the township, cost was not a factor.
- The security lighting is working well, the interior rope lighting is on a dusk to dawn timer but set to go off two hours after dusk.
- The wireless security camera works great. I wish I had spent the extra money for a network camera but it is still fun to watch them argue for the roosting spots.
- The door in the floor works fine. The birds adapted to it quickly.
Now that it is done, I'm glad I decided on the height and design. It is much easier to clean and work around the coop.
- The Little Red Barn
- › *~*Runner Duck Club*~* 18 seconds ago
- › The American Paint Silkie 33 seconds ago
- › d'anver lovers,discuss the breed and post some pics! 36 seconds ago
- › Hi everyone, rather new this chicken raising thing. Nice to know... 46 seconds ago
- › TINY Mystery Egg! 58 seconds ago
- › Dwarf Chick??? 1 minute ago
- › Proposed Changes to USPS Charges for Shipping Chicks 1 minute ago
- › Dead 2-day-old Runner Duckling, no idea what happened...(cross-post... 1 minute ago
- › ARTIFICIAL INSEMENATION 1 minute ago
- › My chickens are sick, please help!!! 2 minutes ago
- › Cream Legbar originally bred by R. C. Punnett by KPenley
- › Silkie by Chickie Mama
- › Brahma by Chickie Mama
- › Leghorn by Lisasfeathers
- › Andalusian by nova022
- › Mini Cup Automatic Waterers by KPenley
- › Barred Rock by applefalls
- › Australorp by applefalls
- › Star by applefalls
- › Partridge Plymouth Rock by cybercat
- › Hatching<3 by Nike
- › Blue and Whie Delight by 12chickenlover3
- › Coop La Fiesta by jpruett86
- › The Truth About Insuring Hatching Eggs by Poultry Friend
- › Gabe's "budget coop" by GabeStalker
- › Burnsville Minnesota by sn0wwhite
- › ♥♥♥♥A chicken... by OnceInALifeTime
- › Where Chicks Rule by woodsygal
- › What I didn't know about ducks... by BCBunnies
- › 2seth2 breeder page by 2seth2