So my one , 1/13 egg hadnt hatch yet so i candled it the night be fore last seen tha it broke into the air sack so i placed it back in the bator the next day watched for movement nothing so tonight i candled it and there was no change so i poked a hole in the shell where the air sack is and carefully peeled the shell , looks like it died after getting into air sack
SymptomsProbable CauseCorrective Measures
Pipped eggs, but died without hatchingInsufficient moistureIncrease humidity (wet-bulb temperature) during the hatching period.Improper ventilationIncrease ventilation rate in incubator and/or room, but avoid drafts.Improper setting of eggs causing malpositioned embryosSet eggs with small end down. Turn eggs properly but avoid turning within 3 days of hatching.
Pipped eggs that do not hatch
If chick embryos develop to the pipping stage, or at first shell cracking at hatching, they are normally healthy enough to hatch unless some incubator adjustment prevents it from happening. The problem is usually caused by either 1) poor ventilation or 2) improper humidity.
The air exchange requirement within an incubator is greatest during the last day of incubation. The chick embryo's oxygen requirement continually increases during development and especially when breathing using the respiratory system just before hatching. The vent openings are frequently restricted at this time in an attempt to boost incubator humidity. Instead of helping the chick hatch, the chick is suffocated from lack of ventilation. Never decrease ventilation openings at hatching in an attempt to increase humidity. Increase humidity by other methods. If any vent adjustments are made, they should be opened more.
Another reason for mortality during hatching is improper humidity adjustment. The deaths can be produced from too much humidity during the entire incubation period or from too little humidity during the hatching period.
The desired egg weight loss during incubation caused by water evaporation is about 12 percent. If humidity during incubation is kept too high, adequate water evaporation from the egg is prevented. The chick can drown in the water remaining in the shell at hatching. A dried coating around the chick's nostrils and beak indicates that drowning was likely. Attention to maintaining proper incubation humidity during incubation will reduce the potential for this problem at hatching time.
If the humidity is allowed to decrease after the chick pips the shell, the membranes within the shell can dry-out and stick to the chick. This prevents the chick from turning inside the shell and stops the hatching process. The chick eventually dies. If the membranes around the shell opening appear dried and shrunken, the cause is probably low humidity during hatching. This condition can occur quickly (within 1 or 2 minutes) when the incubator is opened to remove or assist other chicks that are hatching. When hatching begins and proper incubator conditions are attained, the incubator should never be opened until after all chicks are hatched and ready for placement in the brooder.
chick looks big, what did the back look like, feathering?
congrats!!!! yours is prettier than mine!!
Edited by Sally Sunshine - 2/7/16 at 4:42am