New Posts  All Forums:Forum Nav:

Auto Turner Question

post #1 of 6
Thread Starter 
I have an Farm Innovators Auto Turner in my incubator right now and would like to take a couple rows out of the turner. I can't seem to figure out how to remove them. I can get the one side out but with the side that turns them, I can't seem to get it removed.

Suggestions?
post #2 of 6
I’m not familiar with that specific turner but this link gives some vague directions at the bottom in the washing section, something about turning them vertical and lifting them out.

http://www.farminnovators.com/catalog/Model3200automaticeggturnerinstructions.pdf

If it’s not obvious when you try to do that and if you don’t get a good answer on here, try calling the manufacturer and ask them.

When you come to a fork in the road, take it.

 

"If you make every game a life-and-death proposition, you're going to have problems. For one thing, you'll be dead a lot." — former North Carolina coach Dean Smith

 

http://www.backyardchickens.com/a/how-much-room-do-chickens-need

Reply

When you come to a fork in the road, take it.

 

"If you make every game a life-and-death proposition, you're going to have problems. For one thing, you'll be dead a lot." — former North Carolina coach Dean Smith

 

http://www.backyardchickens.com/a/how-much-room-do-chickens-need

Reply
post #3 of 6
The ends have flat edges. Carefully separate the turner from the motor and move the side so that the flat edges on the pegs are vertical and slide pegs from the the racks upward out of the side.HTH
post #4 of 6
Thread Starter 
Quote:
Originally Posted by Ridgerunner View Post

I’m not familiar with that specific turner but this link gives some vague directions at the bottom in the washing section, something about turning them vertical and lifting them out.

http://www.farminnovators.com/catalog/Model3200automaticeggturnerinstructions.pdf

If it’s not obvious when you try to do that and if you don’t get a good answer on here, try calling the manufacturer and ask them.

Thanks! I'll look at the attachment!
post #5 of 6
Thread Starter 
Quote:
Originally Posted by 1655ot View Post

The ends have flat edges. Carefully separate the turner from the motor and move the side so that the flat edges on the pegs are vertical and slide pegs from the the racks upward out of the side.HTH

Ohh.. That's great! I'll try that!!
post #6 of 6
Thread Starter 
I got one out! wee.gif. Thanks for the help everyone!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Incubating & Hatching Eggs