Zomestead
In the Brooder
- Sep 2, 2022
- 19
- 33
- 49
OMG! Contact paper! Thank you - That is so GENIUS!!! I loathe the top of the heater, so I’m definitely doing that next time.
Here is my set up in a large plastic tub. I have a Brines heater that I adjust as the chicks get older. For feeders, I rigged up 2-inch PVC with a 90 degree elbow and short section of pipe to which I have attached an end cap that I cut at a 90-degree angle to form a little feeding trough. I cut holes in the tub to insert the feeders so I can mount them to the outside with zip ties and save room in the brooder. For water, I have a 4-nipple waterer on a short section of PVC with a hose connection. The hose is connected to an elevated 5-gallon bucket to which I have attached a garden hose fitting. I elevate the bucket enough that there is enough water pressure to supply the nipple waterers. Last year I used a rubber mesh mat cut to fit the bottom of the brooder and put pine shavings on top. This year, I did not even bother and just put the pine shavings in with no problems. I've tried various solutions to make the cleanup of poop on top of the heater easier (because the chicks love to get up there and poop), but I think contact paper is the best bet - just peel it off and throw it away when messy, then replace with a new piece. It sure beats scraping and scrubbing every few days. Lastly, I do have a simple screened top that can go over this because it is amazing how quickly the chicks figure out how to get out. Of course, the first thing they when they get out is to poop on the floor, so the top goes on after about a week or so.
Love the whole setup! I haven’t conquered the watering via PVC/nipples but I really want to. This is just such an awesome setup.