New and improved version -outside-
I'm not really sure where to put my thermostat or fan, but this is what I have so far. Heating element and light-bulb are at the top.
New and improved version -outside-
Materials: (1) GQF turbo-fan and wafer thermostat (1) 12v computer fan (1) drill (8) #8-32 x 2" bolts with the nuts with 'em. (1) bit that can drill a hole big enough for the bolt to fit through. But not too big. And one that'll drill a 1/2" hole for the red light that shows you if your incubator is on or not. (1)phillips drill bit. (1) 10 ft roll of 3/8" x 3/4" foam tape. *optional* (6) screws, and (1) latch, if you want it to close. (1) automatic turner. Or if your dresser is larger than 27"L x 18W, 2 turners. *not guaranteed all information is accurate. And your incubator probably has the screws from the manufactorer. Mine were too short and rusted to reuse. All the measurements and sizes, I looked up from the packages and the info is right. Finished version. I took the front of the drawr and hinged it onto the middle shelf. I also added another fan(inside top right) that's connected to my other incubator(didn't have a converter for the 12v pc fan). I improvised a bit on a few things. I'm a cheap-o and only bought the foam tape for $5.99; I had everything else literally sitting around collecting dust. It hold easily 60% humidity and stays between 97-102* at 60-76 degrees fahrenheit. I can almost fit 2 auto turners in it... almost... grr... Out of 3 seccessful incubators, this is the only one that required 0% parental help. So, anyone who isn't afraid to get shocked wiring in the second fan(it's optional, though) and can use a drill can easily make this. It takes 3 hours, tops. Most of my time went into pulling stuff apart. A ruler is greatly advised! And be careful not to get burnt by your heating element. P.s. I didn't measure anything, I guessed and so I have about 6 extra holes on he top and sides for ventilation. P.s.s. I hatched 10 button quail and 1 coturnix(so far) in it. I don't quite trust it to do full-term yet. And if I did i'd put in guinea or duck eggs. They're harder to kill with temperature spikes. *I used several ideas in this that were from other BYCers. Like the styrafoam tape. I'll keep altering and changing things until I have it completely right and eliminate and hot/cool spots.
Fourth incubator. Old model GQF turbo-fan etc. Attatched to the top of an old dresser. Step 01.
kellyn

New and improved version -outside-

There are no comments to display.

Media information

Album
Chicken and Incubator pictures
Added by
kellyn
Date added
View count
576
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom