Another version of my stove pipe feeder, Pics inside come take a look

Discussion in 'Coop & Run - Design, Construction, & Maintenance' started by GallowayFarms, Jun 12, 2008.

Thread Status:
Not open for further replies.
  1. GallowayFarms

    GallowayFarms Chillin' With My Peeps

    148
    2
    111
    May 19, 2008
    This is just like the other feeder just using another connection method.

    This time I used metal fabric pins, that you get for holding down weed barrier. Some local lawn and garden places sale these. Hardware store would prob have something that would be close too it.

    My overview shot.
    [​IMG]

    To connect the pipe to the pan all you need to do is drill 4 holes in both the pan and the pipe. Then run the pins through the holes. Remember two of the holes need to be drilled higher so the pins don't meet in the middle at the same level. Here shows the holes.

    [​IMG]

    Here is a view down the stove pipe.

    [​IMG]

    I can hang these or leave them on the ground.

    Good Luck

    Nick
     
    Last edited: Jun 12, 2008
  2. Run-A-Muck Ranch

    Run-A-Muck Ranch Chillin' With My Peeps

    Very Creative!!!!!!! [​IMG] I am sure the birds are going to love eatting out of it.....You did a great job....

    Now if I only had that creativity......
     
  3. DuckLady

    DuckLady ~~~Administrator~~~BYC Store Support Staff Member

    32,515
    1,300
    521
    Jan 11, 2007
    Washington State
Thread Status:
Not open for further replies.

BackYard Chickens is proudly sponsored by