See here how the bottom 3" are pounded flat, pre-drilled, then screwed to the base
See how I screwed through the ends and into the last hoop. I predrilled these holes with a tiny drill bit
A 20" length of furring strip is used to attach the ends of the hardware cloth to the base. I used 1 3/4" deck screws.
Hardware cloth is overlapped by one square then ziptied to the conduit. I put several close together at the base and space them out further towards the top. If you had a heavy predator load, i would put many zipties on.
See here how the bottom 3" are pounded flat, pre-drilled, then screwed to the base
Hardware cloth is overlapped by one square then ziptied to the conduit. I put several close together at the base and space them out further towards the top. If you had a heavy predator load, i would put many zipties on.
Here is the hoop house with the ends on. The ends are 1/2 plywood. I screwed the whole sheet to the base once the hoops were on, traced the arc, then took the sheet off and cut it with a jig saw. I eyeballed the door with a circular saw.
KlopKlop

See here how the bottom 3" are pounded flat, pre-drilled, then screwed to the base

There are no comments to display.

Media information

Album
Hoop Tractor
Added by
KlopKlop
Date added
View count
432
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom