I've been trying to arrange a solution for car window elevator motor, but it is too fast for this. all the other 12v motors i've found nearby are either too fast, or don't have enough power.
Today I managed to get a barbecue axle motor, which is quite powerfull and is only 2rpm which sounds perfect. The bad part is that it's 220V, which doesn't fit in the diagram Gpop1 provided
This motor spins CW, CCW, CC, CCW, etc every time it is turned on/off.
I was thinking in putting an analog power outlet timer turning this on for 15 mins (minimum time for these analog timers), then stop and start every 1 hour, and put a limit switch to stop the circuit when the table reaches 45º angle.
The problem is once the limit switch is opened (pressed) the circuit won't start when the timer is activated in the next time...
Is there any simple way of solving this with this 220V motor?
Today I managed to get a barbecue axle motor, which is quite powerfull and is only 2rpm which sounds perfect. The bad part is that it's 220V, which doesn't fit in the diagram Gpop1 provided
This motor spins CW, CCW, CC, CCW, etc every time it is turned on/off.
I was thinking in putting an analog power outlet timer turning this on for 15 mins (minimum time for these analog timers), then stop and start every 1 hour, and put a limit switch to stop the circuit when the table reaches 45º angle.
The problem is once the limit switch is opened (pressed) the circuit won't start when the timer is activated in the next time...
Is there any simple way of solving this with this 220V motor?