Once framed in and painted, we then started building the joists for the bottom floor. We settled on 36" high from the ground level for the bottom floor. This would leave plenty of room to build a second floor to house and roost more chickens. Note that the nesting areas extend an additional 2 feet on each side of the coop, while the middle of the coop was recessed to run around the back side of the tree.

We decided that 30" ceiling would be perfect to start the second floor of the coop. The second floor would only extend another 2' outside of the nesting area. The center of the coop would have ramps that led to the second floor on each side of the coop.

Once the initial roof was on, we started cutting and laying the floors and back wall. Note that the plywood for the floors was cut around the studs, so that it would slide in and fit fairly snug. Any crevices were subsequently filled in with spray foam, then sanded and painted over. The floor was then coated in a rubberizing product called Blackjack #57. Also note that on the back wall, we cut out a window to view the inside of the coop from the shed. This window would be covered in hardware cloth and then framed in.

After framing in the bottom floor, we continued to reinforce the studs with cross braces and paint all the wood going in. At this point we had also painted and cut the plywood for the initial roof base.

Once framed in and painted, we then started building the joists for the bottom floor. We settled on 36" high from the ground level for the bottom floor. This would leave plenty of room to build a second floor to house and roost more chickens. Note that the nesting areas extend an additional 2 feet on each side of the coop, while the middle of the coop was recessed to run around the back side of the tree.

We placed all studs 2' on center; turning them on their edge. We also left room on the far right corner to build the entry door for the run. We also ended up framing through the rafters, around the tree to add increased strength and durability for the roof.

Because there is water run off from the tool shed, the height of the coop closest to the shed would be higher than the far side. We settled on a 5 degree slope, calculating that it would be enough for water drainage; especially since we would end up putting gutters on the outside. The height of the side furthest away from the shed ended up being right around 7 feet tall. This should be plenty of room for an entry door and head clearance.

We then filled the cinder blocks with the dirt/clay that we had dug up, and ran chicken wire into the ground on the inside of the cinder blocks. This should be enough to deter any predators from trying to dig under the foundation.

Once framed in and painted, we then started building the joists for the bottom floor. We settled on 36" high from the ground level for the bottom floor. This would leave plenty of room to build a second floor to house and roost more chickens. Note that the nesting areas extend an additional 2 feet on each side of the coop, while the middle of the coop was recessed to run around the back side of the tree.

tbonius
Feb 24, 2016

There are no comments to display.