plapczynski
Songster
It you have access to an air compressor you can buy a tool called a "nibbler" that cuts like butter.....
What's the best way to cut metal/tin siding
- Thread starter arlee453
- Start date
You can get an attachment that turns a normal drill into a nibbler, too.
- May 13, 2008
- 10,684
- 186
- 321
The best, easiest and fastest way is to make a simple wood jig using bailing wire as a cutting device. in a nutshell you take two peices of 2x4 wider than you need, then hammer a stout nail on the bottom 2x4 to one end, and wrap the wire around it tightly, lay your tin down , line it up then just place a 2x4 on top step on it, and pull it. it will slice a piece of tin in like 2 seconds. it may take a little pratice but you will save time and money plus your friends will think you are so ingenious.
I hope this helps good luck.
I hope this helps good luck.
Similar threads
New posts New threads Active threads
-
Latest posts
-
-
Pullet or cockerel 6 week old blue laced red wyandottes
- Latest: Vaprairiebluebells
-
-
-
-
Latest threads
-
Pullet or cockerel 6 week old blue laced red wyandottes
- Started by Vaprairiebluebells
- Replies: 0
-
-
-
need advice - neighborhood rooster found with head injury/exposed skull
- Started by denialism
- Replies: 4
-
Is this enough ventilation for my chickens?
- Started by Mangomochi
- Replies: 1
-
-
Threads with more replies in the last 15 days
-
-
-
Checking-In On Peeps - Post Here To Say Hello!- Started by Nifty-Chicken
- Replies: 146
-
-
Can I get some help from someone with careless neighbours who own dogs.- Started by RiDaGeckoGuy
- Replies: 102
-