pelon la troka
In the Brooder
90's that will be nice ....I have 50% maybe I am doing something wrong
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
thank you!Nice hope you do good
somewhere around the 25-30% range for incubating, bumping up at lockdown ten percent the first day and another 10 percent the next day until I have it between 55-60% for hatch day is what I'm shooting for. a few good friends with cabinets who have great success with those numbers are prompting me to go for that range and see. I'm hoping for 85% hatch rater or betterSo what humidity level are you going to aim from 1-18 days?
I did a 1" hole in the back behind the fan, and a 1" hole on the side, 4 1/2" from the top and 3" back from the side. I also drilled a 3/8" hole to run the temp sensor through, but it could have just as easily gone through the vent hole on the side. The big this with the drink fridge is the plastic inside. It will melt directly under (or I guess above) the insulators. The tech at GQF told me just to mount some metal in the top, then mount the insulators to that. Which didn't make any sense to me, because after I made the metal box to put around the original heater that was in it, IT got too hot to touch, and in my mind that would melt the plastic and be a fire hazard. The foil faced styrofoam insulation seems to be working great. I did take the screws out and drill holes all the way throught the top, and put a fender washer between the insulator and the foam.What size holes did you end up with and are they both at the top? As soon as I have some time I will be covering a drink fridge as well. great job making it work so well and good luck with the hatch