Hi i was wondering if I could get some assistance on where to locate my ventilation fan..lower front, lower rear etc? Im using a 42 watt 3" ventilation fan that will be controlled by my incubator's electronic controller the reason i want to use it is that when the incubator is open or just turns on from being off during test runs the temp raise up to about 101degrees then falls back down to the set temp. Im hatching quail so temp needs to be no higher than 100 i have the controller set at 99.5 i have 4 small vent holes in the incubator 2 are about 3/8" in diameter and the others are an inch all are up high on the incubator the holes where already existing so i left them becuase if i was going to have to block them off it would not be a problem. The incubator does have a 6 inch fan blowing over the heating element. Any assistance welcome pictures attached