1hr 30min since plug-in time. Time 11:29am **at 10:33am I opened the lid to add my temp/humidity sensor into the egg tray. The temp dropped down to 98f but recovered back to 99.5f within 1 minute. At this time I also put the plug back into the vent hole.**
2h 16m since it was plugged in. Time 12:15pm My added sensor that sits in the tray is now reading nearly the same as the display readout. I figure it is only a fraction lower because it sits lower in the tray than the probe that comes down from the motor/display. My humidity reading shows 34% and the arrow on the humidistat on the incubator lid is right in the middle of the "Incubation Period" block. Temperature in my house, in this room, hovers around 67-70f and humidity is around 20-23%.
2h 5min since plug-in. Time 12:04pm
1hr 30min since plug-in time. Time 11:29am **at 10:33am I opened the lid to add my temp/humidity sensor into the egg tray. The temp dropped down to 98f but recovered back to 99.5f within 1 minute. At this time I also put the plug back into the vent hole.**
24min's after plug-in. Time 10:23am
16min's since plug in time. Time: 10:15am Notice the HTR is now at 51%.
15min's since plug in time. Time 10:14am
14min's since plug in time. Time: 10:13am
jbher

1hr 30min since plug-in time. Time 11:29am **at 10:33am I opened the lid to add my temp/humidity sensor into the egg tray. The temp dropped down to 98f but recovered back to 99.5f within 1 minute. At this time I also put the plug back into the vent hole.**

There are no comments to display.

Media information

Album
IncuView Incubator
Added by
jbher
Date added
View count
546
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom