Prev
3. Glue end cap with 1" hole on bottom of tee with the hole opposite the of the sweep side of tee.
Next
Prev
6. Cut trough
4. Install fill valve
5. Mark out for your cut-out. (about 1/3 of the circumference of the pipe) leaving 2 or 3 inches on each end intact.
3. Glue end cap with 1" hole on bottom of tee with the hole opposite the of the sweep side of tee.
2. Glue clean-out fitting top of tee.
Materials needed: 1- 4" PVC (DWV) sanitary tee, a length of 4" DWV (whatever length you desire, 2- 4" DWV Flat end caps, 1- Clean-out fitting with cap, 1- toilet fill valve. 1. Drill a 1" hole in one of the end caps. Center of hole is 1" from edge of cap.
Next
KDK1

3. Glue end cap with 1" hole on bottom of tee with the hole opposite the of the sweep side of tee.

  • Media owner KDK1
  • Date added
There are no comments to display.

Media information

Album
ARCW (automated redneck chicken waterer)
Added by
KDK1
Date added
View count
366
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom