4. Install fill valve
10. Glue the other end cap to the trough
7. dry fit and mark with witness mark to ensure proper alignment.
6. Cut trough
4. Install fill valve
5. Mark out for your cut-out. (about 1/3 of the circumference of the pipe) leaving 2 or 3 inches on each end intact.
3. Glue end cap with 1" hole on bottom of tee with the hole opposite the of the sweep side of tee.
2. Glue clean-out fitting top of tee.
KDK1

4. Install fill valve

There are no comments to display.

Media information

Album
ARCW (automated redneck chicken waterer)
Added by
KDK1
Date added
View count
473
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom