7. dry fit and mark with witness mark to ensure proper alignment.
8. Cut hardware cloth circle. (place a piece of pipe on it and trace around it. Proper fit is important.
11. Glue the trough to the sweep side of tee
10. Glue the other end cap to the trough
7. dry fit and mark with witness mark to ensure proper alignment.
6. Cut trough
4. Install fill valve
5. Mark out for your cut-out. (about 1/3 of the circumference of the pipe) leaving 2 or 3 inches on each end intact.
KDK1

7. dry fit and mark with witness mark to ensure proper alignment.

There are no comments to display.

Media information

Album
ARCW (automated redneck chicken waterer)
Added by
KDK1
Date added
View count
937
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom