Bottom view of the port pieces just set in place and not glued yet.
The cots figuring out that food goes here. Took them less than ten seconds to mess with it. I learned for my next set to place the holes closer to the base (I didn't have the caps in hand to mark the edges when I cut them) and to use one size bigger PVC for the port baffles- cut shorter and in half instead of two thirds to keep it from pouring out the bottom of the holes and make sure it's wide enough. As you may be able to tell from the photo, their heads just barely fit and I have to keep it a little higher than ideal to keep it from hitting the bottom of the cage.
Finished product! Hung with fencing wire, capped with a normal slip cap for a lid and a screw on drain for a base to make cleaning easier.
Side view of ports before gluing.
Bottom view of the port pieces just set in place and not glued yet.
The pieces, except for the ends which I got the next time I had time to work on it, and my main tool for the job.
Sycamore27

Bottom view of the port pieces just set in place and not glued yet.

There are no comments to display.

Media information

Album
PVC Quail Feeder Mock-Up
Added by
Sycamore27
Date added
View count
556
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom