I put some bushings in to help hold the fan in place. I also used the pill bottle method to allow for ventilation. I have two on bottom left and one on upper right.
This is the back. I ran a hose with a squeeze bottle so I can add more water if needed for humidity. Notice the cute flip flop pull chain. I bought the lamp with intentions of putting it in my daughters room after I was done with first incubation. I'm not sure its going to make it there.
This is where I can adjust the water heater thermostat without opening the lid. Also the other pill bottle to allow for ventilation.
I put some bushings in to help hold the fan in place. I also used the pill bottle method to allow for ventilation. I have two on bottom left and one on upper right.
I place the viewing window on the side of the incubator and made it so that it can be opened and closed so I do not have to remove the lid on top. I was hoping might help keep from letting all the heat escape when turning the eggs. I also thought it might help the kids get a better view.
I used a water heater thermostat. I have it on screws that I can adjust from the outside to move it closer or further away from the bulb. I can also adjust the temp from outside of the incubator. I also am using the water jars this time to help keep temp steady.
I've managed to get incubator to hold a temp of 99.5 with no more than a .5 variance.
Mommafixit

I put some bushings in to help hold the fan in place. I also used the pill bottle method to allow for ventilation. I have two on bottom left and one on upper right.

There are no comments to display.

Media information

Album
Homemade Incubator
Added by
Mommafixit
Date added
View count
259
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom