Metal roofing going on. I ordered these sheets custom pre-cut, so they span full length with no horizontal seams.
We had a crank out window left over from constructing our house basement because the contractor made the opening the wrong size. This seemed like a perfect place to finally use it. All the walls are packed with vapor barrier fiberglass batts, and since contractors were already here doing some insulation repair in our house, we had them spray foam the inside of the roof in both the coop and storage area.
The building is 8X8, divided in to two 4X8 sections. The tall portion on the left is storage, and the raised section on the right is the coop. You can see below, a couple of the vents added to the crawl space below storage.
Interior walls are 1/4" OSB.
Metal roofing going on. I ordered these sheets custom pre-cut, so they span full length with no horizontal seams.
Setting the initial bracing and roof trusses. The uprights are four feet on center. This allowed easy access as the build progressed. After the structure was largely completed, the remaining uprights were added at twenty four inches on center, and doubled up for strength.
After the gravel was set and leveled, I covered with heavy landscape fabric, followed by a layer of 1/2" hardware cloth. Nothing is digging its way in to this coop! Much sand was then added on top of the hardware cloth in the run. The small gravel area is the crawl space under the storage section. I added vents in the sides to keep moisture from becoming a problem under the floor.
That's a one cubic yard bucket, and I filled it four times with washed gravel to make a good drainage base.
med1pilot

Metal roofing going on. I ordered these sheets custom pre-cut, so they span full length with no horizontal seams.

There are no comments to display.

Media information

Album
Chicken coop
Added by
med1pilot
Date added
View count
513
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom