The piece of steel ejector pin epoxied in place with JB-Weld. The unit is back in operation and working great. Thanks for reading
Next
Prev
The piece of steel ejector pin epoxied in place with JB-Weld. The unit is back in operation and working great. Thanks for reading
The 3/32" steel ejector pin I cut and used for the new post. You can see the blind press fit hole I drilled into the case.
The broken plastic post that held the gear
The tip of the screw indicating where the plastic post that held the gear in place was located.
Add-A-Motor D-20 failed after 7 months of use
Updated on March 22, 2012 I finally added the trim and cover to conceal the motor. It really reduced the sound of the motor.
Next
G-Man

The piece of steel ejector pin epoxied in place with JB-Weld. The unit is back in operation and working great. Thanks for reading

  • Media owner G-Man
  • Date added
There are no comments to display.

Media information

Album
Automatic Pop Door
Added by
G-Man
Date added
View count
359
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom