Using Devcon Rubber Adhesive, glue flat rubber washer to edge of LARGE end of coupling. This is the side where you will place the egg. The rubber washer is a little wider in the inside dimension so the rubber washer will mold nicely to the egg to seal the light. Pkg of 1@ 1" Rubber Union Washer = $.79
Insert 2 rubber O rings (one at a time) inside the SMALL end of the coupling. Roll them down inside until they seat nicely up against a lip that is in there. This helps to seal the light around the top of the mag light and the coupling. You can see there is one down inside already. Pkg of 2@ 15/16" (ID) - 1 1/8" (OD) - 3/32" (Wall) Molded Rubber O Rings = $.79
Using Devcon Rubber Adhesive, glue flat rubber washer to edge of LARGE end of coupling. This is the side where you will place the egg. The rubber washer is a little wider in the inside dimension so the rubber washer will mold nicely to the egg to seal the light. Pkg of 1@ 1" Rubber Union Washer = $.79
Finished DIY Egg Candler Took a whole 10 minutes to make! I brought the flashlight into the plumbing department and then found the parts to best fit my flashlight. Mini Mag Light (77 lumen) = $20 1@ 1"x3/4" SXS Coupling = $.79
ChezPoulez

Using Devcon Rubber Adhesive, glue flat rubber washer to edge of LARGE end of coupling. This is the side where you will place the egg. The rubber washer is a little wider in the inside dimension so the rubber washer will mold nicely to the egg to seal the light. Pkg of 1@ 1" Rubber Union Washer = $.79

There are no comments to display.

Media information

Album
DIY Egg Candler
Added by
ChezPoulez
Date added
View count
372
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom