Two of the friendliest roos I have had were both rescued. The first one I picked up at a former job. I worked a public works job and animal control had brought in a young roo (about 6-9 months old) that had been either hit by a car or dropped from a truck. Poor guy was found in the street. One...
If you're leary of mineral spirits or cheicals as a product to remove oil film, you can also use distilled vinegar. It works great for me on some things. I would highly recommend spray paint as well. The primer is definitely the most critical step. I've heard of zinc chromate before. Sounds like...
Okay. Just an update to this issue. I di a couple weeks of Pen-G injections into his breast, every other day as well as alternating sides. Kept his foot bandaged, cleaning it every day and using some chlorhexidine ointment I got from the vet applied directly to the wound. I kept him in a cage...
Those vents should work fine. Your thoughts of putting them up as high are spot on. The overhang idea would also work. A general rule of thumb is about 1 sq foot of ventilation per bird. If you're converting that measurement to inches, 1 sq ft is the same as 144 sq inches. Just make sure the...
Hello all. I have been treating my RIR roo for a missing toenail that became infected. The first time, I squeezed the infection out, bandaged him, I made the mistake of just letting him back out with the girls. The toe swelled up even larger and I had to do it over a week later. I...
Okay. A bit of an update. While the rest of his legs and his other toe with what seemed to be frostbite look better, his one toe had swollen a bit more. He was getting around better than before, but I could tell that one toe still bothered him greatly. So, I just got through with the operation...
Another vote for fixing the shed. Just a few pieces of old metal over the roof hole and some scrap plywood over the floor holes till you can do it all correctly. I only have $400 in my whole minibarn (10x12). Everything but the siding and floor joists was from scraps/give away. I used a 1x3...
Yes. The above post is correct. I dunno how keen you are as far as math or basic geometry goes, but think also like this: Draw a square (or rectangle, triangle, etc) on a piece of paper. You are working in 2 dimensions, length and width. Now picture floor space. Same thing. Length and width...
Okay, I soaked his feet in warm water and epsom salt this morning as well as cleaned them so I could see better. The black mark on the middle section of his toe was dirt. Both middle toes are swollen at the tip, but I'm leaning toward frostbite as a possible cause. The other toe still has it's...
Bump. Watched him a little more this afternon before work. He is definitely favoring his other foot, so it is causing some discomfort. I have everything needed for surgery tomorrow if it comes to that. I plan on soaking his feet in warm salt water for a few minutes and see from there. Any other...
Hello all. I noticed my RIR roo seemed unsteady on his feet at times, especially when he tries to sit down or lay out in the grass. I concluded his spurs probably needed trimming. He is an awesome roo, and calm around people, so I usually don't remember his spurs till he is high stepping over...
I live a bit north of you in TN. My coop is framed, then walled on the outside with smartsiding as well as lined inside with thin plastic paneling. No insulation. I have a large window on the east wall that has an awning that I close during the winter. Got down to -10 here a few nights recently...
Yeah, I had the same deal when I needed 2 windows they no longer kept in stock. It would take them 3+ weeks to order and recieve them at a cost of nearly $500. I looked online. I can order them and have them shipped to the same stinkin' store in less than 2 weeks. Total cost, less than $300.