jnicholes's latest activity
-
jnicholes replied to the thread Ended Indoor Plant Show—2025 BYC Summer Fair.I’m labeling this as entry one, because my first entry was labeled as three before it got moved here. A successful catch on the... -
-
jnicholes replied to the thread Ended Indoor Plant Show—2025 BYC Summer Fair.Tell you what, I might as well make all my entries carnivorous plants. Sundews usually eat flying insects that fly on the leaves. The...
-
jnicholes replied to the thread Ended Indoor Plant Show—2025 BYC Summer Fair.Entry number two. Drosera capensis “wide leaf” bloom. Another carnivorous plant.
-
-
jnicholes replied to the thread Ended Indoor Plant Show—2025 BYC Summer Fair.Carnivorous plants do bloom. I’ve been able to get my sundews to bloom also. I think I have a picture, let me find it and put it as an...
-
jnicholes replied to the thread 3-D printing.Finished printing. Even at 50% it’s size, it’s very detailed.
-
-
jnicholes replied to the thread 3-D printing.Thank you for the advice, I will definitely have to look into this Blender software. However, it turns out that there were some errors...
-
-
jnicholes replied to the thread Ended Outdoor Garden Show—2025 BYC Summer Fair.Quick question. I noticed that one of my entries was moved to the indoor garden show. There’s no problem with that, I think it belongs...
-
jnicholes replied to the thread Ended Indoor Plant Show—2025 BYC Summer Fair.Just replying so I can get notifications, mainly because one of my entries from the outdoor show was moved here.
-
jnicholes replied to the thread Any artists out there?.Thank you. I actually discovered some errors in the model, so I’m not done yet.
-
jnicholes replied to the thread 3-D printing.I guess my model is a little TOO good for the slicer. The slicer keeps running into errors. I had to switch to a different slicer that I...
-
-
jnicholes replied to the thread Any artists out there?.I put this on the 3-D printing thread as well. I figured it would fit here cause technically its sculpting, which is an art. However...
-
-
jnicholes replied to the thread 3-D printing.FINALLY DONE WITH THE DESIGN!!!! I must say, I’m quite proud of this model.
-
-
jnicholes replied to the thread 3-D printing.A long long time ago, when I was in elementary school, we had an art project using clay. My teacher taught us how to make pottery. I...
-
-
jnicholes replied to the thread Any artists out there?.Different kind of art. Used Solidworks to make a 3d model of a vase I used to make out of clay in school. It’s a 3d printable...
-
-
jnicholes replied to the thread Would you enter?.You have a point. @CCsGarden We need to plan more. I understand you want this contest to take off, but we need to plan more. I don’t...
