Sorry, but I have yet another question about the install of Tuftex panels.
Their instructions are a bit limited.
Question: which side is up. Should the panel begin with the side edge up? or down?
I would have presumed down, but I read somewhere that you want to start with the outside edge up....
but, if that is the case, connecting two panels where they overlap would result in screwing in a valley. not a peak as specified.
What have you all done?
Their instructions are a bit limited.
Question: which side is up. Should the panel begin with the side edge up? or down?
I would have presumed down, but I read somewhere that you want to start with the outside edge up....
but, if that is the case, connecting two panels where they overlap would result in screwing in a valley. not a peak as specified.
What have you all done?
