I am trying to design my coop, and I just came across the idea of deep litter. I like this! We were planning to try and elevate the coop off the ground enough to alllow the flock to hang out underneath and deter pests. I'm trying to understand the construction of a coop floor. We were going to make the coop a lean-to design, attached to our existing utility shed. The coop would be on the side, with part of the run, and then the run would extend in an L-shape around the back of the shed as well. We plan on having a flock of between 10-15 hens, without a rooster, and we are in South GA, where it gets very hot. With the deep litter method, as I understand it, you rake the pine shavings about once a week and/or throw in some scratch to encourage the chickens to help you out. Then once a year, you take out all the composted litter to use in the garden. Most sites seem to encourage an earthen floor, to help the composting process. If we elevate the coop, that's not an option. Also, we came across the idea of putting linoleum on the floor for easy clean up. I read the forum describing the feeder and water locations as well with this method. However, I'm still a little confused about the best way to make the floor work. Should the deep litter method be attempted over a linoleum floor? Would it be helpful to first throw down some dirt first to help composting? Should I give up the idea of an elevated coop, and just use an earthen floor? It would be cheaper, but I worry about pests and predators. Maybe there is a method that involves elevating the floor with wire or something that allows the shavings to go through but won't get the chickens feet stuck? Thanks for any help!