Problem with roller type incubator

[HoundsNTrout]

I don't hatch many eggs really but I purchased a roller type of incubator. Anyone have problems with the eggs all heading to one side of the incubator then falling off? OR is the problem possibly bc its not perfectly level? OR maybe adjust the width of the rollers from each other? Only thing I have done so far is make certain the thing sits level. I'll check eggs again half way through the day. They are small GUnkei eggs right now. No directions on what to do or problems adjusting what-ifs.

 

[HoundsNTrout]

Admin, or anyone else. I can not figure out how to delete this thread as it seems to be started by someone else. Thanks

 

[FlyMac]

I don't hatch many eggs really but I purchased a roller type of incubator. Anyone have problems with the eggs all heading to one side of the incubator then falling off? OR is the problem possibly bc it’s not perfectly level? OR maybe adjust the width of the rollers from each other? Only thing I have done so far is make certain the thing sits level. I'll check eggs again half way through the day. They are small GUnkei eggs right now. No directions on what to do or problems adjusting what-ifs

 

[FlyMac]

Hi,
I found this post searching a similar issue with new incubator.
When I put my eggs with apex (pointy end) to the left with rollers rolling away from front I found they bunched up against the wall on the left.
When I then rearranged apex to the right they all stayed in the same position.