Search results for query: *

you will need to add tubes to each dish so you can fill them because eggs will be above.

its a cooler, if you dont put a trillion inch size holes in it, it will hold humidity well, thats why I love the cabinet cooler bator better than those expensive ones, not only the insulation but its plastic no loss of much of anything...... all of mine have the same three food dishes in the...

Ditch the top fan that will dry out the eggs too much you have plenty of side air space open at the turner I use small frozen meal plastic dishes of all sizes and compartments in the bottom so I can add water in small amounts or fill for lockdown as needed.

not sure on the bulbs even with the heat block on top, as that will get hot as well, just not sure how hot. The main issue is not getting those hot spots, if I were to do it I would fight myself until I put them lower and protect the plastic from buring with those heat blocks and place fan a...

If you really dont want to buy a new cooler, just raise the turner a bit, and put them on the bottom rear, but VERY important to think about air flow and where you think it will be best to promote that flow so that the lights dont get hot spots on the eggs. the fan has two jobs not just...

I guess you may have to raise it a bit and put lights on bottom an make sure you have a very good fan in it. and when you set temps make sure your temp towards the top of the egg is close to the bottom so you know your turning air around good enough, you can use cans or whatever under the...

whatsa whizzer?

because the yolk floats upward I dont feel like diving into info for you but get and egg and candle it and watch the yolk

KIT

TORCH!!!!!!!!!!!!!!!!!!!!!!!! dont you dare!!! silly woman!!!

I see what your saying it would need how much play to move those outer rails? even more than what you gave it there in images?

Howdy Bonnie!

cut small slits big enough to fit in outer rails only tightly

did that make sense at all? not sure how to explain

I wonder if you could use a dremmel and run slits down on each side of the bator to allow it to sink a bit more but not go all the way to the bottom OR further than the rails need to turn, it does look like you have some room to rails even if you need to take off the straight piece on the...