anyone know if this is a good incubator?

Pics

quailmama 82012

Songster
Dec 27, 2019
289
567
216
Show Low, Arizona
  • KEBONNIXS 12 Egg Incubator with Humidity Display, Egg Candler, Automatic Egg Turner, for Hatching Chickens




KEBONNIXS 12 Egg Incubator with Humidity Display, Egg Candler, Automatic Egg Turner, for Hatching Chickens
by KEBONNIXS
i haven't had good luck with hatching quail so far. once my hens start laying i want to hatch more babies again but i want more than 1 (1 out of 26!!). i think that last time it was the incubator, and high humidity issues. this next time i want to be extremely prepared. I really don't know humidity issues and what i should do about that, and i need to find a second hand hydrometer to use for backup.
so, anyone had any experience with this incubator?
what should my humidity be at?
anyone know of a good hydrometer?
thanks!
 
I've incubated a few hundred quail at 50% humidity buit I always had a couple splayed leg or curled toes. I now incubate at 35 and I haven't had any issues. I run 60-70% during lockdown.

Can't comment on that incubator but whether you buy a $50 one or a $700 one you still need a separate thermometer/hygrometer that you have tested for accuracy. I own several of these and they have worked well....

https://www.amazon.com/ThermoPro-TP...qid=1586552261&sprefix=thermom,aps,159&sr=8-5
 
https://incubatorwarehouse.com/incubator-thermometer-hygrometer.html

I'm using two of these with good success. Be sure to calibrate the humidity and temperature for the most accuracy and confidence.
One sensor = no clue
Two sensors = no clue which is correct
three sensors = the two that match are good, third needs to be adjusted.

I run humidity for coturnix at 20-30% in a Styrofoam Hovabator with good hatch rates (when fertile!) until lockdown then bump it to 40-50%. Try it and see what works for you. I am at sea level in a swamp. Don't really get dry air.

Cheers and happy hatching!
 
i live in a dry place where it averages about 25%. ( i would much rather have a humid area to live in.) i will look up those thermometers, thanks!
Can't really calibrate the thermometers on the combination units in a water bath without ruining the humidity detector. Put the sensor in a plastic bag to keep them dry, then immerse in ice water for low end calibration. Distilled ice water if you want accuracy.

I use a mercury thermometer for the calibration of the upper end 100°F. Don't boil the hygrometers. Mercury thermometer rated for greater than 300°F boiled to confirm upper end. Cooled and place in bag, jar or incubator next to the combination units. If all three read within a degree, no issues.
 

New posts New threads Active threads

Back
Top Bottom