I have the bucket mounted under the lean too side of coop. the bucket on top is my pvc feeder. ( this picture was taken before the outside waterer but is under the window)

I keep a lid on to keep debris out

a piece window screen held down by a big nut to stop little stuff from going down the pipes

All the pipes are 3/4". I didn't even glue them together. they are tight enough that they don't leak. One goes into the coop one goes under.

The one under the coop is just attached to the wire with some u-bolts attached to some wood blocks screed to the wire. I cut a piece of 4"pvc pipe in half to catch the water that gets dripped when the drink.

And here is the one inside

Again mounted with u-bolts. I put a bock of wood behind it to hold it away from the wall. To attach the u-bolts I just held the bolts where I wanted them. tapped with a hammer to mark it, and drilled a hole as close to the size of them, and pushed them in. no nuts on them. Looks like its time to clean the 4"PVC again

I keep a lid on to keep debris out
a piece window screen held down by a big nut to stop little stuff from going down the pipes
All the pipes are 3/4". I didn't even glue them together. they are tight enough that they don't leak. One goes into the coop one goes under.
The one under the coop is just attached to the wire with some u-bolts attached to some wood blocks screed to the wire. I cut a piece of 4"pvc pipe in half to catch the water that gets dripped when the drink.
And here is the one inside
Again mounted with u-bolts. I put a bock of wood behind it to hold it away from the wall. To attach the u-bolts I just held the bolts where I wanted them. tapped with a hammer to mark it, and drilled a hole as close to the size of them, and pushed them in. no nuts on them. Looks like its time to clean the 4"PVC again
Last edited: