Coop resurrection-Update 6/9-Moved in and mostly DONE!

chicken995

Chirping
8 Years
Mar 19, 2011
134
0
99
Northern Colorado
I began my coop resurrection project today. Thanks to everybody who supplied me with plenty of advice in my other thread.

It seemed to me, and several other members here at BYC, that the roof was a big concern. So I started in on that today.

Here is what it looked like.
IMG_9673.jpg

IMG_9674.jpg


The corners were in really bad shape.
IMG_9676.jpg


Here is it with the asphalt shingles removed.
IMG_9678.jpg


Notice the vent hole that had been covered by the asphalt shingles.
IMG_9679.jpg


And here it is with the wood shingles removed and all cleaned up.
IMG_9684.jpg

IMG_9686.jpg

IMG_9685.jpg


This is what is going to go on as the new roof. Not too fancy or pretty, but I had it left over from a car port, so it will be the most cost effective route.
IMG_9677.jpg


I've got some stuff to do in town tomorrow, so probably to report until Wednesday afternoon. Keep those suggestions coming if you have them.
 
Last edited:
That will make a great coop. And I like the metal roof idea. They last forever.

Rufus
 
They make a foam rubber "snake" looking thing about 4 feet long called "formed closure". You put it under the bottom edge of the roof metal to keep the yellowjackets from making nests up in the ribs.
big_smile.png
AND since they like "old" wood structures best for chewing on for material, use about all the paint you can buy at Habitat, on the exterior. The only color that counts is the top coat.
big_smile.png
AND waa laa you are going to have a PALACE!!! Congrats.
P.S. if you use tar paper under that roofing, it won't rust ever.
 
Last edited:
Thanks again for all of the tips and advice.

And that formed closure stuff, I'm assuming you can get that at home depot and similar stores. Is that correct?
 
Update-more work on the coop is done. Roof will be completed tomorrow. I think I clean out all of the junk inside after that.

Replaced old rotted wood, with old not rotted wood. Poor men, have poor ways. Do you guys enjoy the flower pattern as much as me?
IMG_9689.jpg

IMG_9688.jpg


Got the tar paper on.
IMG_9690.jpg


Uh-on, looks like a couple of the eaves are shot.
IMG_9694.jpg


But don't worry, I replaced them.
IMG_9693.jpg

IMG_9695.jpg


Roofing is cut and ready to go.
IMG_9691.jpg


This ought to work for ventilation, yeah?
IMG_9692.jpg


Thanks again to everybody for supplying me with ample amounts of advice.
 
I'm going to have to say this is going to be a palace, BUT needs lots more ventilation. maybe cut holes between joists (every other one?) both front and back. Chickens handle cold better than heat, their range is appx. 20 to 80 degrees, ambient. this roof faces south and will gain slightly more heat. did i see windows anywhere? Chickens need ambient light to bet to their roosts at night. Do you live in "cold" country? This looks like a "great plains" State. >>>go to "Patnchickens big ol' ventilation page here on BYC for ideas.

Quote: Two things are sure, 1. this project probably won't just fall together and 2. it very well may just fall apart. Steve Reilly
 
Last edited:

New posts New threads Active threads

Back
Top Bottom