Dumb Question.... How to remove rails from LG Turner?

[kelseygirl707]

Ok, so I need to swap out my chicken egg rails for my quail rails, but I can't seem to pop out the chicken rails, I'm afraid of breaking the turner if I pry too hard, Is there a secret to doing it?

 

[kelseygirl707]

Nevermind, LOL. Looked up the instructions online, DUH! LOL

 

[Zgoatlady]

Im glad you found it can you tell me how to do it. I cant find it on the internet

 

[kelseygirl707]

You have to remove the motor all together (two small screws below it) then you can turn the racks in a way that makes them slide right out.

Here's what the instructions said.

Washing the Automatic Egg Turner
Disassembly:
Place complete Automatic Egg Turner on
a flat surface. Slide power cord horizontally
to remove from notch in base.
Loosen two screws connecting the motor
to base and remove. Slide motor upward,
releasing the white plastic lever from Tbracket
of connecting rod.
Turn connecting rod so offset arms rest in
a horizontal position and egg trays are
vertical. Lift offset arm to release connecting
rod from notches.
Lift individual egg trays by offset arms
while still in a horizontal position from
offset arm notch in base and pull slightly
to release the pin from the corresponding
hole in the base. Repeat with all six trays
until you are left with an empty base.
Place egg trays and base in dishwasher,
run and dry.

Good Luck!

 

[Tashaf]

You have to remove the motor all together (two small screws below it) then you can turn the racks in a way that makes them slide right out.


Here's what the instructions said.


Washing the Automatic Egg Turner

Disassembly:

Place complete Automatic Egg Turner on

a flat surface. Slide power cord horizontally

to remove from notch in base.

Loosen two screws connecting the motor

to base and remove. Slide motor upward,

releasing the white plastic lever from Tbracket

of connecting rod.

Turn connecting rod so offset arms rest in

a horizontal position and egg trays are

vertical. Lift offset arm to release connecting

rod from notches.

Lift individual egg trays by offset arms

while still in a horizontal position from

offset arm notch in base and pull slightly

to release the pin from the corresponding

hole in the base. Repeat with all six trays

until you are left with an empty base.

Place egg trays and base in dishwasher,

run and dry.

So glad this is on here! I didn't know how to either!!

Good Luck!