Homemade Incubator *Pics!*

[77horses]

OK I am still testing the incubator with different methods. Here's the results and infothis is when I only had 2 air holes)

1st try: bottom of bator
*2 air holes near the top(both were open)
*water wiggler highest temp: 103*F.
*Hum. 30-40% with some warm water in bowl
*Fan running, pointing towards light bulb(on the opposite side of light)


1st try: top pf incubator
*2 air holes near the top(both open)
*water wiggler temp: 100-101*F
*Hum. 30-40%
*Fan running, pointing towards light bulb(on the opposite side of light)



Then, since the temp. was a bit too high in the bottom, I cut 2 more holes closer to the bottom. So now I have 4. Right now I'm testing it again in the bottom, with 1 plug in a top hole and 1 plug in a bottom hole. So, there's one open plug in the top and one near the bottom. I'm testing it right now, and I will post results when the temp. becomes steady.
Any thoughts or advice? How does it look right now?
Also, I'm going to see what happens without the fan running.

 

[77horses]

Here are the pics:

whole incubator pic:

this is where the fan is, along with the water wiggler that I made:

this is the light bulb, along with the water wiggler:

and here's the egg turner that I made:

 

[77horses]

OK after a half hour or so, the temp is up to 90.6*F and is slowly rising once and a while. So far, so good?