Homemade Incubator

[Nezocas]

Hi,

I am currently building an incubator, but need some advices ,on possible changes, opinions are wellcome.

It will be made from 1.5 cm´s thick plywood.
With a capacity to 120 chicken egg´s, in 2 automatic rolling trays.
All electronic´s (two 12vdc fan´s / two 40w bulb´s / ultrasonic humidifier / water tray) will be placed inside a side compartiment.
On the outside part of the door, will be placed an XH-M452 temperature and humidity controler, and an digital delay relay for automatic egg rolling.

 

[BigBlueHen53]

I'm impressed! Will follow to see how it works.

 

[Nezocas]

Rolling tray´s will be these ones:
https://www.aliexpress.com/i/33053228302.html

Thermostat an humidity control will be this one:
https://www.amazon.com/Temperature-Humidity-Controller-Accuracy-Automatic/dp/B07RV88Q5G

Ultrasonic humidifier:
https://www.walmart.ca/en/ip/Portab...ma-Diffuser-Sprayer-Aromatherapy/47CDYIMBPCE8

The 2 upper holes will have 12vdc fan´s, extracting the air from the egg chamber to the electronic´s bulb´s chamber, and exiting from the bottom.

In the bottom of the bulb´s chamber will have a bowl of water with the ultrasonic fog maker.

The 12v fan´s will allways be working, to transfer the heat or humidity as needed.
The sensor from the thermostat/himidifier, will be placed in the center of the 2egg tray´s.

My sketchup skill´s are not the best, I still didint manage to draw the placement of the electronics bulb´s fan´s etc etc