So I think I'm going with the shed(pictured below) turned into a coop. This coop will be outside but connected to the run. I'm thinking 5 ft wide and 8 ft deep. I only want it to be about 5 .5 tall with the roof.
So here are the ideas..
The door will be closest to the house, I want to put windows and I'm not sure if I should do one or two on the sides(the two spots in the middle that is open in the picture and directly across from that) will one one each side be good? Are sliding windows a good choice? Where would hardware cloth go, on the outside? Framed in? Ventilation? I was thinking something on the two peeks, opposite each other. Will that compromise the support, especially for the door? Roof, I was thinking of doing that one middle section on one side a clear vinyl for sun(similar to a sky light). Nesting boxes will be along that open area in picture and then multiple levels of roosts. The door for them will connect to the run. The coop will be surrounded with electric fence and hardware cloth around the bottom. The foor? I was thinking vinyl tile and then figure out the cover later(sand, shavings, etc) I was also considering putting insulation in and drywalling/painting the inside. Is that to much? Is insulating it not worth the time?
So here are the ideas..
The door will be closest to the house, I want to put windows and I'm not sure if I should do one or two on the sides(the two spots in the middle that is open in the picture and directly across from that) will one one each side be good? Are sliding windows a good choice? Where would hardware cloth go, on the outside? Framed in? Ventilation? I was thinking something on the two peeks, opposite each other. Will that compromise the support, especially for the door? Roof, I was thinking of doing that one middle section on one side a clear vinyl for sun(similar to a sky light). Nesting boxes will be along that open area in picture and then multiple levels of roosts. The door for them will connect to the run. The coop will be surrounded with electric fence and hardware cloth around the bottom. The foor? I was thinking vinyl tile and then figure out the cover later(sand, shavings, etc) I was also considering putting insulation in and drywalling/painting the inside. Is that to much? Is insulating it not worth the time?