Problem with generic Chinese incubator

[Michael99]

I've had this incubator for about the past 2 years and it has worked fine until now. For whatever reason, on the control panel it says that the humidity is at 0%, when I know for a fact it isn't, and it keeps setting off the humidity alarm as a result (I'm pretty sure 0% humidity is impossible, and I just cleaned it earlier today after a previous hatch, and there is still visible water bubbles and condensation on the inside). I have no clue as to what is going on.

I don't really care what the humidity reads (I can monitor it myself), I just want to know how to disable the alarm so it isn't going off every 5 minutes.

Any suggestions?

And for reference it is a generic incubator with a yellow slanted top and clear plastic bottom that I bought off of Amazon a few years back.

 

[JMC91]

Is it basically the janoel 12 but looks slightly different?

 

[JMC91]

Never mind that one doesn’t have an alarm. Hope someone can help!

 

[Michael99]

Thanks for the reply!

It's this one, not entirely sure what it is called though

 

[ShannonsChimkens]

I found this to be helpful to turn off the alarms. I don’t have the link to the thread, but saved screen shots.

 

[Michael99]

Thanks for the help everyone, I turned the humidity down to 1 (the lowest it would go), and the alarm still kept going off.

This morning as I was just about to throw it out, I plugged it back in and it worked! I have no idea what changed, but I'm not complaining.