Still air incubator

My 30 chicks took about 24 hours to hatch. By the end they were going crazy. Its a still air farm innovator and says it holds 42. It seemed extremely overcrowded with just 30. And they were practically screaming. So I took them out. Some were dry for a day and others barely but they're all fine now. Then in the brooder they all passed out and it scared me but that's normal too.
 
Being a little crowded in the incubator for a couple days won't hurt them, what I get concerned with is the heat and humidity in there, last time my humidity was very high, I couldn't see in the windows because of the condensation once the eggs started pipping and hatching, this time I am going to try to start lockdown at a slightly lower humidity.
 
Thank you so much Blucoondog for your input, I'm not seeing anything that suggests growth yet either. Waiting until day ten to try again sounds good, here's hoping at least a couple of them are productive. I'll keep updating. :)
 
My first hatch I tried a partial load in the incubator and used the thermometer that was provided with the incubator which needless to say was a piece of garbage, it didn't go well at all I didn't have anything hatch, I got a new thermometer and put in a full load of eggs for my 2nd try, I didn't candle until day 10 and when I did I had embryos swimming in all but a few eggs which were clears, I was very surprised and happy with my results, I lost a few more before hatch and 3 died during hatch for some reason, couldn't get out of the eggs. I ended up with a 66% hatch rate which I was satisfied with for my first hatch from a Styrofoam incubator. I think not fussing with the eggs early on makes a difference as that is when the embryos are at their most fragile point.
 
My thermometer is just a Taylor bulb thermometer from fleet farm, they had probably 20 different thermometers hanging near each other I looked them over and picked one that seemed to have consistent readings with others, my hygrometer is a little round one from a pet store made to stick to the side of a lizard aquarium, we got it at a pet store, just a cheapo but is right on the money. My thermometer cost a little over 3 dollars I'm not sure about the hygrometer since my wife bought it but I assume it was under 5 dollars as well. I don't like digital s I tried using digital medical thermometers at first and they didn't work right.
 
Hours away from being day eight of incubation, I candled two of those Silkie eggs again, one looked clear and another looked dark at top with a couple of very small veins in the clear part. I put it back to wait for day ten when I will candle all of them but I felt movement in the egg, really neat! Here's hoping we'll end up with a couple of chicks after all. :) Thanks for sharing your experiences with me Blucoondawg, very helpful and greatly appreciated! Nervous first time egg mom here! :D
 
Day ten I candled eggs and no signs of life, cracked one open and the white was partially cooked, apparently incubator was too hot. I'm guessing somewhere between day two and three because I can see a spot with small veins floating in the rest of eggs and I do remember catching temperature rise then. What a bummer, off to buy another thermometer and more eggs, even though they were shipped across the US, they were fertile and the air sacs intact. I think the movement I felt was the egg cooling and popping on the inside, not a chick, this was the partially cooked egg, when candled it looked darker too, harder for light to pass through solid. Definite learning experience and on a positive note maybe we'll hatch now closer to when the kids are out of school for summer break. Thank you all for your input, greatly appreciated!
 
Last edited:
Thanks for the info, blucoondawg! Going to get that stuff before I do my next incubator batch. Right now I have 6 broody hens, though! 5 old english game bantams and 1 ameraucana.
 

New posts New threads Active threads

Back
Top Bottom