what am i doing wrong?????

pokey

Warrior Princess
11 Years
Joined
Jun 1, 2008
Messages
1,313
Reaction score
6
Points
171
Location
upstate
ok, i bought shipped eggs. 8 out of 12 developed. all is good......until day 18. on day 18, i removed the egg turner and the plug dropped
on one of the eggs and cracked it. crap!!!!
he.gif
ok, i put tape on it. remember this egg..... the humidity has been 65% or close to it for 18 days. on day 18 i raised the humidity to 75?% or close to it. i have a hovabator and the temp stays at 99 and sometimes will read 100 for a minute then goes back to 99. on hatch day one egg pipped, but the only chick to make it was the one i broke.
idunno.gif
. i did a test run a few weeks ago w/ shipped eggs and my own and all of mine hatched except one, but the last chick was getting stuck in the shell.
none of the shipped eggs developed. i opened two of the eggs to see if the chicks in this batch were alive but stuck, but two were alive but died right after i opened the egg(the first was the one that pipped)the last few i opened there was really thick fluid. is it the humidity? i thought if it was too high the chicks would drown? any suggestions would be greatly appreciated as i am at my wits end.
barnie.gif
 
I just asked what the humidity was supposed to be for the first 18 days. I was told 35-40% and then 65-75 during lockdown. The humidity may have been too high in the beginning.
 
This would only be a guess but I would say humidity too high. I set mine similar to the above poster said. Did the ones with thick fluid only have that or chicks too?
 
Alot of things can go wrong with shipped eggs. I had a bad hatch this past week. But, it sounds like the humidity might have been a little too high. 65% humidity is only recommended during the last few days of incubation. But, I don't think you ever really truly know the exact cause. I'm sure there are people out there who hatched at that %. Many factors play a roll in the successes and failures of artificial incubation.
hugs.gif
 
if it is too high then why do the chicks seem to stick?
 
Quote:
Did you open the incubator during lockdown? Is so, that could be a cause.
 
Hi Lisa in Cowpens! If I had to guess, I'd say your humidity was too high overall.
...the humidity has been 65% or close to it for 18 days. on day 18 i raised the humidity to 75?% or close to it

Were you trying to keep it at 65% or are you just in a humid spot?
Lisa in Aiken​
 
if you look up incubating eggs on google most of the sites say to use 60-65% humidity for the first 18 days then one says use80-85% the last 3. the instructions with the hovabator doesnt have an exact % it only says to fill both bottom trays the last 3 days. so what should it be? the chicks seem to be too dry, but what made them die in the shell?
 
Last edited:
Hey Lisa
frow.gif

I agree with the above posts To high will cause alot of problems Especially in the first 18 days I use a Brinsea and it says 45-50% the first 18 days then 65% during lockdown Sometimes with a new bator it can take a bit to figure it out Keep using and trying different things and keep notes for reference and eventually it will work out When I get a slack week Keep your eyes on the mail

Mike
big_smile.png
 

New posts New threads Active threads

Back
Top Bottom