Auto Turner Question

[ambe0487]

I have an Farm Innovators Auto Turner in my incubator right now and would like to take a couple rows out of the turner. I can't seem to figure out how to remove them. I can get the one side out but with the side that turns them, I can't seem to get it removed.

Suggestions?

 

[Ridgerunner]

I’m not familiar with that specific turner but this link gives some vague directions at the bottom in the washing section, something about turning them vertical and lifting them out.

http://www.farminnovators.com/catalog/Model3200automaticeggturnerinstructions.pdf

If it’s not obvious when you try to do that and if you don’t get a good answer on here, try calling the manufacturer and ask them.

 

[1655ot]

The ends have flat edges. Carefully separate the turner from the motor and move the side so that the flat edges on the pegs are vertical and slide pegs from the the racks upward out of the side.HTH

 

[ambe0487]

I’m not familiar with that specific turner but this link gives some vague directions at the bottom in the washing section, something about turning them vertical and lifting them out.

http://www.farminnovators.com/catalog/Model3200automaticeggturnerinstructions.pdf

If it’s not obvious when you try to do that and if you don’t get a good answer on here, try calling the manufacturer and ask them.

Thanks! I'll look at the attachment!

 

[ambe0487]

The ends have flat edges. Carefully separate the turner from the motor and move the side so that the flat edges on the pegs are vertical and slide pegs from the the racks upward out of the side.HTH

Ohh.. That's great! I'll try that!!

 

[ambe0487]

I got one out! e. Thanks for the help everyone!