- May 8, 2009
- 29
- 0
- 32
As I said previously, the 8' x 8' 2x4 frame was assembled and painted.
This morning, my dd and I raised the frame into the air so it was standing on one 8' member. We laid one cattle panel on the frame and used fence staples to secure it. Laid down the second cattle panel and secured it.
Here's where it gets trickey.
I started bending one panel up towards the center and had dd grab it while she was still holding the frame upright. When I got to the second panel, she had to move to the center of the frame to grab the panel.
Spring loaded frame whizzed down towards me and caught me in the upper thigh. We don't have an emoticon for immense pain.
If we did, I'd insert it here.
Needless to say, the frame torqued and ripped out the screws on the ends.
We can salvage the other three sides, but the side with the wire staples in it with the cattle panel attached to it has to be replaced. Next time, I will use a rope to hold the two ends of the panel in curve. Also going to use some metal L shaped brackets on the top and bottom of the corners. That will secure it until the panel is attached. Then we will put the 2x4 cross braces on the corners.
Sheesh! I thank God that I didn't get hurt any worse.
Soooo...anybody going to assemble one of these hoop houses....learn from my mistake.
ChickeryChick
This morning, my dd and I raised the frame into the air so it was standing on one 8' member. We laid one cattle panel on the frame and used fence staples to secure it. Laid down the second cattle panel and secured it.
Here's where it gets trickey.
I started bending one panel up towards the center and had dd grab it while she was still holding the frame upright. When I got to the second panel, she had to move to the center of the frame to grab the panel.
Spring loaded frame whizzed down towards me and caught me in the upper thigh. We don't have an emoticon for immense pain.
If we did, I'd insert it here.
Needless to say, the frame torqued and ripped out the screws on the ends.
We can salvage the other three sides, but the side with the wire staples in it with the cattle panel attached to it has to be replaced. Next time, I will use a rope to hold the two ends of the panel in curve. Also going to use some metal L shaped brackets on the top and bottom of the corners. That will secure it until the panel is attached. Then we will put the 2x4 cross braces on the corners.
Sheesh! I thank God that I didn't get hurt any worse.
Soooo...anybody going to assemble one of these hoop houses....learn from my mistake.
ChickeryChick