Chinese incubator busted bottom

[justoldbobo2]

Has anyone else had the plastic bottom for their Chinese type incubators bust. I was going to try and patch it. And put in frame then spray foam around it. But not sure if that would bust it more. I found bottom online but it is UK only. Any Ideas or suggestions?

Or should I try building bottom out of wood?

 

[2 many chickens]

I had it and it sucked.
It's big and bulky and constantly beeped if the temperature dropped, which it did often because it couldn't keep a steady temperature..
It also beeped it the humidity went below 55 which I like to run my humidity lower than that.
I had a terrible hatch rate with this incubator.

 

[justoldbobo2]

I had decent hatches 50-60% hatch rates. But Had an old baby bumper wrapped around sides to help insulate. Main reason liked it was automatic turner. I have homemade bators with better hatch rates and temp control but they are all manual turn. Haven't hatched in 2 yrs because swapped to working out of town and didn't have time .