Monday was cold and rain.
I have both jointers all finished and waxed.
Monday I worked on the table saw. Got it ready
for it's final sanding with 350 grit sandpaper.
I will try to get it sanded and waxed today.
then on to the planer. the bed on that is not very large.
should be done quickly.. I have it soaking with Blaster.
despite the up and down temperatures, the rhubarb
is growing . One pear tree is doing OK, apples and plums
are just barely budding..
this week should wake things up with temps
in the 70F's..
I have a very old Husqvarna zero turn that I
started reviving last summer. this summer I am
going to take the mower deck all apart and
re grease the bearings. It needs a couple of
new V Belts. I ground the valves and reset
them to their proper gap. I spent a lot of time
on you tube , researching..
I have both jointers all finished and waxed.
Monday I worked on the table saw. Got it ready
for it's final sanding with 350 grit sandpaper.
I will try to get it sanded and waxed today.
then on to the planer. the bed on that is not very large.
should be done quickly.. I have it soaking with Blaster.
despite the up and down temperatures, the rhubarb
is growing . One pear tree is doing OK, apples and plums
are just barely budding..
this week should wake things up with temps
in the 70F's..
I have a very old Husqvarna zero turn that I
started reviving last summer. this summer I am
going to take the mower deck all apart and
re grease the bearings. It needs a couple of
new V Belts. I ground the valves and reset
them to their proper gap. I spent a lot of time
on you tube , researching..