Quote:
The main frame was a greenhouse kit...it came with the straight posts that are pounded in the ground every six feet. It also came with the curved arches that attach to two posts on each side. Then we used 2x6 and went around the whole perimeter at the bottom. Next, we put the long metal pipe (perlin) across all of the arches(the pipe that is at the top of all that arches) Next we added 2x4s around the whole thing 16" up from the 2x6. These were then used as an easier way to attach the osb sight barrier. To add extra support we attached the osb to 2x4's on the inside too (as you see in some pictures). Next we framed out the ends with 2x4's and also put the door in. Then we attached chicken wire to both ends....stretch it tight and put lots of zip ties on it....then we put the flight netting on. This took a lot of hands and had to be pretty precise. We began by attaching the netting to one end and stretched it across. To attach the netting to the sides, we used 1x2's and stapled the netting underneath them...you can see it in the first two pictures....then we attached the netting to the other end (again, lots of zipties!) Then we attached the wire around, pretty self explanatory. Finally we brought dirt and filled in the sides outside and the perimeter inside.
This is a pretty brief guide, but hopefully it answers some questions...maybe i should make a big how to in pdf form with pictures and everything!
