Ever wonder how I spend my evenings...
Back story: the 150 egg hatcher pooped out. The heating elements had burnt out and i needed it up and running. We (with remore intruction converted from heat rods to light bulbs. Now we need to fine tune it.
ok. now.... the incubator. i cant understand why you think its not working, if lights go on and off, if fans are working and if temp is between 37 and 38 it is working.
8:26 PM
put thermometer on shelf and measure max temp after 5 minutes, do the same for each shelf. give me results
8:27 PM
Yes it is working but the problem is heating is not enough to eggs.
8:28 PM
We just need to fine tune it Please measure temp on each shelf
8:29 PM
OK after lunch
8:32 PM
the incutherm plus can I remove the black thing to the back.
10:07 PM
what is black thing on incutherm plus. please take photo
10:08 PM
OK cover to the battery.
10:09 PM
you need to change battery?
10:10 PM
How many min or time to used the incutherm?
10:10 PM
just put the sensor on shelf for 2 mins
10:11 PM
51% 96.3
10:16 PM
50% 35.9 second floor
10:21 PM
where is the thin black probe from thermostat located in the incubator?
10:24 PM
Yes
10:25 PM
where in incbator? near top? near bottom? in middle?
10:26 PM
48% 37.5 first floor
10:26 PM
From the top to the floor.
10:27 PM
is 1st floor the lowest floor?
10:27 PM
Yes
10:28 PM
ok
10:28 PM
are both fans on orange pipe with screws?
10:28 PM
Yes
10:30 PM
ok
10:31 PM
Floor 42% 39.3
10:32 PM
the tip of the black probe (soft black wire) from thermostast should be on middle shelf
10:33 PM
It should be under the mesh with legband zip tie
10:34 PM
I try every floor good for 2 min.
10:35 PM
not from incuview - from thermostat
10:35 PM
Put in the box?
10:40 PM
Put inside to the incubator?
10:41 PM
In incubator under second floor - yes
10:42 PM
Where is it now?
10:42 PM
Other end attached to back of thermostat
10:42 PM
139 kB photo of hygrostat device with the same loo as a new thermostat sent to me
10:47 PM
thats new. I mean the original one in the incubator now
10:48 PM
How to used these? The wire from the old transfer to the new?
10:50 PM
no no - do not use new!!
10:51 PM
open incubator and take photos
10:51 PM
117 kB photo sent to me of incubator
10:53 PM
please do not use that - its not a thermostat. it is to control humidity when we build a 3000 egg incubator room LOL
10:54 PM
158 kB photo sent to me of the rear of the thermostst
11:03 PM
141 kB photo sent by me circling the thermostat wire
11:04 PM
the black wire circled on picture i am sending
11:04 PM
What I'm doing?
11:19 PM
find the black soft wire on the back of the thermostat picture I sent just now. Follow wire to find the tip inside the incubator. Place tip under second shelf with zip tie
11:21 PM
I use the new?
11:26 PM
no. just use the old one - its already in the incubator. find it and move it.
11:26 PM
Dodong used the new wire
11:26 PM
why?
11:27 PM
please just follow the old one
11:27 PM
I find the wire. Next?
11:28 PM
Follow wire to find the tip inside the incubator. Place tip under second shelf with zip tie
11:28 PM
OK.next?
11:31 PM
good job!!
11:31 PM
ok now see if we have any 50 watt light bulbs - 220 V or 110V
11:32 PM
80 watt light used.
11:33 PM
I know - the thick glass gets too hot. try and find 50 watt
11:34 PM
All lights is 80 watts
11:35 PM
Lillian - there are 40 and 50 watts that we use for piglets
11:36 PM
clear glass
11:37 PM
Change 80 to 50 watts?
11:41 PM
yes please and then wait til thermostat gets to 37 and measure temps on each floor again using incutherm thermometer
11:42 PM
103 kB photo of 8heavy glass floof lights0w
11:45 PM
So no red and black boxes with 40 or 50 watts?
11:47 PM
No all is 80 watts
11:47 PM
ok - then remove one 80 watts
11:48 PM
57% 35.6
11:48 PM
is temp on thermostat 37?
11:49 PM
One 50&80?
11:50 PM
do you have 50?
11:50 PM
Yes from the tangkal
11:51 PM
do you have 2?
11:51 PM
Yes
11:51 PM
OK - use 2 x 50
11:52 PM
I used one 50 &80 52% 36.8
11:56 PM
what shelf?
11:56 PM
Yes
11:57 PM
ano floor?
11:57 PM
Middle
11:59 PM
FEBRUARY 17, 2015
when temp in middle is 36.8, what is temp on thermostat?
12:00 AM
Controller is37.3 incutherm is 51%&37.1
12:02 AM
OK on second floor??
12:03 AM
Controller 37.9 incutherm 46%39.5
12:06 AM
First floor
12:07 AM
The 80 watt is too hot. The glass is too thick
12:07 AM
You need 2 x 50 watt
12:08 AM
OK
12:08 AM
Hinay hinay is ok
12:09 AM
Good job
12:09 AM
I back to weed the house area
12:18 AM
lets finish the incubator measurements
12:18 AM
Controller 37.9 incutherm 48% 37.9
12:20 AM
please include floor
12:21 AM
Floor controller 37.0 incutherm 46% 36.9
12:23 AM
ok shelf 1?
12:25 AM
Sa light floor
12:26 AM
i am confused, 4 floors. ground, 1, 2, 3. and 3 is top
12:27 AM
From the floor to up
12:27 AM
do not measure ground floor
12:27 AM
measure 1 and 3
12:28 AM
Controller 37.0 incutherm 45% 37.3 1st
12:29 AM
Controller 37.9.incutherm 46% 38.0 2nd
12:32 AM
Controller 37.1 incutherm 48% 37.2. 3rd.
12:34 AM
OK GOOD!
12:34 AM
1st floo still a little hot. but ok
12:35 AM
you can use to hatch eggs . put mix eggs on floor 1, purebreds on floor 2 and 3
12:36 AM
on ground floor put an icecream container or bowl of water
12:37 AM
For what?
12:38 AM
during days 1-19, humidity is good at 45% but when eggs hatch, it is better at 80%, The water will help. increase humidity.
12:40 AM
Ok
12:41 AM
the plan is to make incubator room for incubation, room with chick boxes for hatching
12:41 AM
but we need new room for tools
12:43 AM
thank you lillian and dodong for working well. I think i will try smaller bulbs so there will be more even heat
12:51 AM
i will ask inday to buy 40w
12:54 AM
No prob. your nice to us.that way I back you good
12:54 AM
Work
It can be done