GopherBoys smalles tallest coop~Update 6/24/2009~

[island.girlie]

GopherBoy you're halerious!

Looks like a nice start to your coop. Wish hubby was this motivated

 

[GopherBoyFarms]

island.girlie :

GopherBoy you're halerious!

Looks like a nice start to your coop. Wish hubby was this motivated

oh gawd if we just started this is going to be a long ride, LOL

~Tiff~​

 

[Wildsky]

We're along for the ride with you!

SEATBELT on! (I might put a helmet on later)

 

[chicken_angler]

 

[EweSheep]

 

[Poulets De Cajun]

Where did "Gopherboy" come from? And I dont mean, where was he birthed, I mean where'd he get the nickname?

 

[Chicabee19]

Where did "Gopherboy" come from? And I dont mean, where was he birthed, I mean where'd he get the nickname?

I've been wondering that too!​

 

[Wildsky]

Quote:
MY GAWD, have you seen those TEETH - and the whole family has em........

 

[GopherBoyFarms]

Measure off the deck surface to the ground or pad.

all measurements must carefully be written down on a block of wood, using anything else would not be professional

using a construction calculator we figure out our rise for our steps.

mark on the framers square the rise and the desired tread width with a sharpie pen (more details on the measurements in the following drawing)

line up both marks on the square to the edge of the board and trace them out.

Skillfully cut the lines out with a skill saw then use a hand saw to finish the cuts

On the last tread cut the thickness of your treads off the bottom, in this case the tread thickness is an inch and half

there’s the stringer…being tested out.

then we screwed the treads on

done deal…..there are steps to the deck. Time to quiet for tonight

 

[GopherBoyFarms]