How to turn off Brisnea turn alarm?

[Tre3hugger]

Set up my Brisnea yesterday. It's working great, but every time the auto turner does it's thing(every 45 mins) it set's off a high beepy alarm. This is not due to power or temp fluctuation because there is no fault to clear on the display. The noise always correlates with the turning. I noticed a bell with an x through it next to the "ok" button, looks like a mute button, but can't figure out how to operate it or find in the instructions. Do I need to put up with this sound for the next 20 days? Thanks!

 

[BrinseaUS]

To do this you have to go into the calibration menu, which means be VERY CAREFUL. As long as you only change the one setting it will be fine, but definitely don't change any other settings while you're in there.

To open the calibration menu press all three buttons at once ("OK", "-", and "+"). Press "OK" until you see "TURN ALM", then press "OK" again. It should show "T ALM 1". Press the minus button and change it to "T ALM 0". Press "OK" to go through the rest of the menu without changing any other settings.

 

[Tre3hugger]

To do this you have to go into the calibration menu, which means be VERY CAREFUL. As long as you only change the one setting it will be fine, but definitely don't change any other settings while you're in there.

To open the calibration menu press all three buttons at once ("OK", "-", and "+"). Press "OK" until you see "TURN ALM", then press "OK" again. It should show "T ALM 1". Press the minus button and change it to "T ALM 0". Press "OK" to go through the rest of the menu without changing any other settings.

Thank you so much for the prompt and concise reply. Just did exactly what you said, should have fixed the "problem".
Have a great day!

 

[BrinseaUS]

Thank you so much for the prompt and concise reply. Just did exactly what you said, should have fixed the "problem".
Have a great day!

Awesome! You too