- Mar 30, 2011
- 114
- 10
- 196
Hello addictive forum,
I know aproximately what to do for pen, just not sure what goes first. My pen will be 20 by 20, with wire on top.
I assume it goes like this:
1. Put 4 corner posts in the ground, do I need concrete, or is there other way, should I use wood or metal?
2. Put other posts in between every 5 feet.
3. Start stretching the wire on it, how do I join the 4' wire to the height of 8'?
4. Dig a trench to sink extra wire into ground.
5. Add some cables or wood along the top to support the top wire. Is there a way to tent the wire in the middle so it could be higher for flying in the middle?
I am not sure these steps are correct, especially how to make the base. Also i need advice on electric wire. Where to find simple setup kit and how to run it?
Thank you so much.
I know aproximately what to do for pen, just not sure what goes first. My pen will be 20 by 20, with wire on top.
I assume it goes like this:
1. Put 4 corner posts in the ground, do I need concrete, or is there other way, should I use wood or metal?
2. Put other posts in between every 5 feet.
3. Start stretching the wire on it, how do I join the 4' wire to the height of 8'?
4. Dig a trench to sink extra wire into ground.
5. Add some cables or wood along the top to support the top wire. Is there a way to tent the wire in the middle so it could be higher for flying in the middle?
I am not sure these steps are correct, especially how to make the base. Also i need advice on electric wire. Where to find simple setup kit and how to run it?
Thank you so much.
