- Thread starter
- #201
Frosty, all of the information for building this 6 nest box including dimensions are included in the first post. If you want plans for a two nest box you need to email me.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Do you think it would work to use the stuff that they make counter tops out of? Or would the particle board that they probably use in the middle cause a problem?The material I used is called lukabond. It's plastic with aluminum bonded to both sides. It was scrap from a commercial job and not readily available so I would use the AC plywood and shellac it. Shellac dries in 30 minutes and would allow you to apply several coats in the same amount of time as one coat of paint.
The partitions are the boards (walls) that divide the box into individual nest boxes.Looking at the first page instructions, I have a couple of questions before I start cutting:
1) You reference 4 - partitions; what part of the design are they? The boards with the notches/slots cut out?
2) About the 2 ramp platforms and the partitions: How far apart are those notches or slots spaced apart in order to make the 6 equal boxes?
Thanks once again! Can't wait to show you my finished OPA designed rollout!!!