PVC feeder question

Arkantex

Chirping
8 Years
Aug 17, 2011
130
0
89
West Texas
I built a feeder out of 4" thin wall PVC, a 90 degree elbow, and 2 end caps. I know quite a bit of you use them. My chicks make a mess using it. They throw the feed all over the coop. Do ya'lls do this? If so, what did you do to remedy the situation? Thanks
 
Thats a good idea. I was thinking about taking off the old horizontal piece and then putting a new one with holes drilled in it instead of a long slot across the top.
 
I was thinking about taking off the old horizontal piece and then putting a new one with holes drilled in it instead of a long slot across the top.

That would serve the same purpose and probably look better too​
 

New posts New threads Active threads

Back
Top Bottom