This is a poop free water dispenser I found plans for on BYC.....
5 gallon bucket with lid
Pvc threaded male & female connector i used 3/4 some people use 1/2
Two gromets
6ft of PVC and Glue
Three 3/4 T s
Two 3/4 90* * = degree symbol
Four 3/4 45*
four end caps
4 water nipples ....... i ordered mine off the internet im still waiting for them
Its real simple drill a I" hole in the bottom of the bucket
insert the male end of the connector with gromet
screw on female connector with gromet
cut pieces of pvc into 3 one foot sticks and 4 nine inch pieces and
assemble PVC as shown in picture and glue on flat surface
Drill hole in end cap "size varies depending on size of water nipples "
I used silicone on the inside and outside of the bucket where the male and female connector is just to make sure there is no leaks . you can add a ball valve for draining but i was building on a budget
cost about 15 bucks to make .I m sure yall have seen this before but I thought it was too cool not to share
5 gallon bucket with lid
Pvc threaded male & female connector i used 3/4 some people use 1/2
Two gromets
6ft of PVC and Glue
Three 3/4 T s
Two 3/4 90* * = degree symbol
Four 3/4 45*
four end caps
4 water nipples ....... i ordered mine off the internet im still waiting for them
Its real simple drill a I" hole in the bottom of the bucket
insert the male end of the connector with gromet
screw on female connector with gromet
cut pieces of pvc into 3 one foot sticks and 4 nine inch pieces and
assemble PVC as shown in picture and glue on flat surface
Drill hole in end cap "size varies depending on size of water nipples "
I used silicone on the inside and outside of the bucket where the male and female connector is just to make sure there is no leaks . you can add a ball valve for draining but i was building on a budget
cost about 15 bucks to make .I m sure yall have seen this before but I thought it was too cool not to share
