plug it in, heats right up to 100. . .
then 110
then 120
adjust it the tiniest bit,
plunges to72 ( house temp)
repeat.
I put a new therm/humidity digital gauge in at shelf level and its reading cooler, it is mostly staying at 97-101 degrees. Humidity is staying where it needs to be. the old therm. is sitting about 2 inches below the heating wafer and is holding at 110.
OBVIOUSLY this is not a good scenario... but... do you think anything will hatch?
should i worry?
I plan on eventually putting in a really nice thermostat. but i have eggs in there now!
then 110
then 120
adjust it the tiniest bit,
plunges to72 ( house temp)
repeat.
I put a new therm/humidity digital gauge in at shelf level and its reading cooler, it is mostly staying at 97-101 degrees. Humidity is staying where it needs to be. the old therm. is sitting about 2 inches below the heating wafer and is holding at 110.
OBVIOUSLY this is not a good scenario... but... do you think anything will hatch?
should i worry?
I plan on eventually putting in a really nice thermostat. but i have eggs in there now!